Message Areas - "Help Problem with Tunnel1_noturrets.s failed to load"

Train-Sim.Com Message Areas

"Help Problem with Tunnel1_noturrets.s failed to load"

Email this topic to a friend
Printer-friendly version of this topic
Bookmark this topic (Registered users only)
Previous Topic | Next Topic Conferences MSTS Route Design (Protected) Original message
RogAnn (69 posts)
Feb-10-02, 11:44 PM (EST) "Help Problem with Tunnel1_noturrets.s failed to load" Could one of you route builders tell me what files I need and where they should be located. I have this problem in Unterland 2 and in ECML routes,Get the message and you can see that there is no tunnel entrance there. Could this also be fixed by replacing the tunnel1_ noturrets tunnel with the Tunnel_turrets within the route Editor. Are other people having this problem? I seem to have all the files i need yet Tunnel1_noturrets .s will not open .Is this a bad .s file problem??? Thanks for any help! Alert Edit | Reply | Reply With Quote | Top
Table of Contents

Subject Author Message Date ID RE: Help Problem with Tunnel1_notur... dvdhoven Feb-11-02 1 RE: Help Problem with Tunnel1_notur... RogAnn Feb-11-02 2 RE: Help Problem with Tunnel1_notur... dvdhoven Feb-12-02 3

Lobby | Topics | Previous Topic | Next Topic
Messages in this topic
dvdhoven (569 posts)
Feb-11-02, 01:24 PM (EST) 1. "RE: Help Problem with Tunnel1_noturrets.s failed to load" Hi,You can copy tunnel_turrets.ace from the USA1 route Textures folder. You also need to copy the same file from the Snow subfolder to the Snow subfolder.
You don't need the Route Editor.I have seen a simular post before, there is what that Route Control that causes the trouble by removing this .ace file.Dick van den Hoven
Remove | Alert Edit | Reply | Reply With Quote | Top
RogAnn (69 posts)
Feb-11-02, 02:11 PM (EST) 2. "RE: Help Problem with Tunnel1_noturrets.s failed to load" I have checked and I have all the ace,.s,and .sd files in the proper folders and subfolders but still get message about that Tunnel1_NOturrets .s file failing to open????Thanks Remove | Alert Edit | Reply | Reply With Quote | Top
dvdhoven (569 posts)
Feb-12-02, 01:52 PM (EST) 3. "RE: Help Problem with Tunnel1_noturrets.s failed to load" Hi,Don't understand this. You are struggling for weeks with this problem.
Why don't you sweep out the whole ECML and start installing fresh?
Simply delete the whole route folder.
And after installing don't touch that scary Route Control. Leave it as it is. Let the installer run the batch file and see what you get afterwards.Dick van den Hoven
Remove | Alert Edit | Reply | Reply With Quote | Top

Lock | Archive | Remove

Lobby | Topics | Previous Topic | Next Topic