Message Areas - "Another question from a Newbie… "

Train-Sim.Com Message Areas

"Another question from a Newbie..."

Email this topic to a friend
Printer-friendly version of this topic
Bookmark this topic (Registered users only)
Previous Topic | Next Topic Conferences MSTS Route Design (Protected) Original message
ksrap (2 posts)
Jan-26-02, 08:09 PM (EST) "Another question from a Newbie..." OK, I hope this isn't a repeat, but I have gotten MicroDem to work per LawrenceKellie's instructions, downloaded and merged all my quads. Then used the route geometry extractor in MSTS and made my route. Finally I used Demex to change my xyz file into something MSTS should recognize. I go into the route editor and when I open my route, viola!, nothing! Just a flat as a pancake swath of green. The route geo extractor worked, but for some reason Demex doesn't seem to have done the job. Any suggestions? By the way, I am working on the Wisconsin Central from Waukesha to Fond Du Lac, Byron hill area. Alert Edit | Reply | Reply With Quote | Top
Table of Contents

Subject Author Message Date ID RE: Another question from a Newbie.... highball5 Jan-26-02 1

Lobby | Topics | Previous Topic | Next Topic
Messages in this topic
highball5 (53 posts)
Jan-26-02, 08:30 PM (EST) 1. "RE: Another question from a Newbie..." Speaking from my experience, are you sure the area you marked off and extracted in the RGE is the same area the DEMs are for?
Demex will show the number of tiles created and number of tiles skipped when it finishes. If it shows 0 created/xxx skipped, then it couldn't find any tiles to DEM-ize (I think I just created a new word there). I'm sure there are a few other possibilties, but not having selected the right tiles in the beginning in RGE is what bit me in the fanny the first couple times I used DEMs. Remove | Alert Edit | Reply | Reply With Quote | Top

Lock | Archive | Remove

Lobby | Topics | Previous Topic | Next Topic