Notice to all visitors and members of the Train-Sim.Com message forums: If you plan on using a signature banner in your posts, we would like to remind you that there is a maximum size for banners. That maximum is 450 pixels wide by 120 pixels high, and not to exceed 25k. Your compliance is appreciated. FORUM RULES Problems? There are two common reasons for problems with logging in and posting messages. The first is that you are running a firewall that prevents your messages from being sent to the server. The other is that you have cookies disabled; the DCForum software requires cookies to work properly.
All of a sudden I have no texture on the side of 99.9% of my rails sections! The top of the rail has texture on all rail sections. The mask for the railbed works on .1% of each of the sections.I hope the .jpeg uploads xxxxx Nope on the pic. Anyhow, the sides of the rail don't show up, looks like the top is just floating about 4 inches up from the ballast. The other thing is that my ballast edges are not masked and the whole texture shows. Any ideas?Jitny (Bob)Regards Bob
Mobile, AL M&O,M&BSRR,GM&N,GM&O,CSX,IC,SOUTHERN,BNSF,L&N(Old Reliable)
Check your advanced display sliders. Push them all to the right. Then I think you'll see your rails.Cal Rasmussen Beaverton, OR (My email is in my profile)Columbia Gorge Route (Phase 2-- Started)
I wish it were that simple, Cal. I've always had my sliders maxed. I appreciate the prompt cameback, though. The thing that stumps me is that there are track sections lookin good, and some lookin bad in the RE and in the sim.Thanks againBob>Check your advanced display sliders. Push them all to the >right. Then I think you'll see your rails. > >Cal Rasmussen >Beaverton, OR >(My email is in my profile) > >Columbia Gorge Route (Phase 2-- Started) Regards Bob
Mobile, AL M&O,M&BSRR,GM&N,GM&O,CSX,IC,SOUTHERN,BNSF,L&N(Old Reliable)
