Archived thread - Read only Previous Topic | Next Topic
Started by Signalmaster4 posts2 min read
Notice to all visitors and members of the Train-Sim.Com message forums: If you plan on using a signature banner in your posts, we would like to remind you that there is a maximum size for banners. That maximum is 450 pixels wide by 120 pixels high, and not to exceed 25k. Your compliance is appreciated. FORUM RULES Problems? There are two common reasons for problems with logging in and posting messages. The first is that you are running a firewall that prevents your messages from being sent to the server. The other is that you have cookies disabled; the DCForum software requires cookies to work properly.
Archived thread - Read only Previous Topic | Next Topic
Printer-friendly copy Email this topic to a friend
Reading Topic #95
SignalmasterCharter Member · 281 posts
For the signal purest, remove the center amber light from the top head. This doesn't exist in reality. One way to do it: Go to USA1 directory and open the sigcfg file in a Unitext editor. Make a copy of the original to a safe place if you need to restore it. Remove this code or rem it out: SignalLight ( 3 "Amber Light" Position ( -0.004 1.682 0 ) Radius ( 0.10 ) ) and save the file. The next time you run the NEC route, the signals will show the correct top head configuration. If you're not comfortable doing this, send me an email and I'll send you a copy of mine which does work.
Printer-friendly page | Top
Gixxer86gCharter Member · 463 posts
RE: Correction for the NEC Colorlight Signal
Hey,Signalmaster.I was a signalman on the NYS&W for about 3 years.No block signals though,just crossings and a bridge interlocking signal at the Arthur Kill lift bridge on the old Staten Island Railroad.
Printer-friendly page | Top
SoRwy471Charter Member · 364 posts
RE: Correction for the NEC Colorlight Signal
So, do you remove this:SignalLight ( 3 "Amber Light" Position ( -0.004 1.682 0 ) Radius ( 0.10 ) OR:Just the first line.ThxSoRwy471
Printer-friendly page | Top
leemonCharter Member · 53 posts
RE: Correction for the NEC Colorlight Signal
You can REMOVE the entire section:SignalLight ( 3 "Amber Light" Position ( -0.004 1.682 0 ) Radius ( 0.10 ) ) OR, there's also a neat "comment" command that you can use to remove things:comment ( SignalLight ( 3 "Amber Light" Position ( -0.004 1.682 0 ) Radius ( 0.10 ) ) )Notice that I put a "comment (" before the start of the block, and a close paren ")" at the end. Everything inside the comment() will be ignored.Lee
