Train-Sim.Com
MSTS Route Design

Archived thread - Read only Previous Topic | Next Topic

Archived thread - Read only Previous Topic | Next Topic – image 1

Notice to all visitors and members of the Train-Sim.Com message forums:
If you plan on using a signature banner in your posts, we would like to remind you that there is a maximum size for banners. That maximum is 450 pixels wide by 120 pixels high, and not to exceed 25k. Your compliance is appreciated. FORUM RULES Problems? There are two common reasons for problems with logging in and posting messages. The first is that you are running a firewall that prevents your messages from being sent to the server. The other is that you have cookies disabled; the DCForum software requires cookies to work properly.

Archived thread - Read only
Previous Topic | Next Topic

Printer-friendly copy Email this topic to a friend

Reading Topic #66

Charter Member · 107 posts

Just a word of warning for those who haven't spotted it.The Geometry Extractor and Route Editor appear to be using decimal degrees (to .9999 of a degree) rather than degrees and minutes. So after getting your latitude and longitude, you need to convert the minutes, e.g. in MTS parlance 58deg and 45' = 58.7500 degrees.Time to dig out that calculator...

Printer-friendly page | Top

Charter Member · 6 posts

RE: Route Editor - using metric degrees.

You don't need to do any calculating at all. Go to topozone.com and cange the lat lon to from degrees, minutes, seconds to the decimal xx.xxxxx value. Then use the topomaps to pin point your track if it exists - if not you should be able to apporximate the route by seeing the grading where the old railroad passed through hills and valleys.

Printer-friendly page | Top

Charter Member · 20 posts

RE: Route Editor - using metric degrees.

>Just a word of warning for
>those who haven't spotted it.
>
>
>The Geometry Extractor and Route Editor
>appear to be using decimal
>degrees (to .9999 of a
>degree) rather than degrees and
>minutes. So after getting your
>latitude and longitude, you need
>to convert the minutes, e.g.
>in MTS parlance 58deg and
>45' = 58.7500 degrees.
>
>Time to dig out that calculator...
>
so one minute equals ??? decimal degree

Printer-friendly page | Top


[ Home | MSTS Forum | MSTS FAQ | File Library ] Copyright © 2002 by Nels Anderson. All Rights Reserved.

Restored from the Train-Sim.Com archive, captured November 13, 2002. About this archive.